FlexiTail (Reptilian)

A fully 3D-printed super motion tail base

• All tails are fully disassemble-able! Printed in varying numbers of segments, each piece slots into the next using a tight fitting, durable peg. Instead of awkwardly curling your tail up inside a suitcase for travel, simply take it apart and put it back together at your destination!
• Designed to sway side to side but not up and down, you'll be able to walk like it isn't even there.

Durable

• TPU plastic can take an incredible amount of abuse. Pull, kink, stomp, crush... It'll keep its form.
  
• Made of heat-resistant, waterproof materials and adhesives

Squishy

• Despite its strength, only the tail's core is solid. The surface has a satisfying squish to it!

This is just a base, no fur is included

• To see finished examples, check out the gallery page!
• Visit the tail furring tips page for more information on how to pattern and fur your tail

Your tail will ship curled up to keep shipping prices low, and it may have formed a curve and wrinkles because of this

• Don't worry! TPU is a memory material, and will regain its original shape
  
  Run a warm hair dryer over any parts of the tail that got wrinkled to straighten them
  Lay your tail flat for a while, and it will regain its straightness
  
  
  
• Hang your tail up when not in use so that it doesn't form a curve again
• Try not to leave it in very hot places (like a car during summer). These plastics are heat resistant, but doing so may form a more drastic curve
  
• To wash, rinse in a bathtub with cool water